-
Recent Posts
Recent Comments
- togrovictory on HMS Victory’s figurehead is ready!
- togrovictory on HMS Victory’s figurehead is ready!
- togrovictory on Skid Beams pillars
- togrovictory on HMS Victory’s figurehead is ready!
- togrovictory on HMS Victory’s figurehead is ready!
Archives
Monthly Archives: June 2018
HMS Victory’s skylight as 3D printed part
I did a short sprint with an “easy” part after the figurehead beast … the skylight which is located on Victory’s poop deck. The part is again available in various scales at the Shapeways 3D print service shop.
Posted in Uncategorized
1 Comment
HMS Victory’s figurehead is ready!
I am very proud to announce that I finally finished the model of Victory’s figurehead! 🙂 A LOT of work and time has gone into it as well as a lot of headaches and a not responding computer. But finally … Continue reading
Posted in Uncategorized
22 Comments
Set of HMS Victory’s lanterns as 3D printed parts
While still struggling with the figurehead (found a solution but still have to implement it), I modeled the 4 lanterns of HMS Victory. Three of them are placed at the stern and the smallest (admiral’s lantern) is featured on the … Continue reading
Posted in Uncategorized
Leave a comment
Binnacle available as 3D print
As I have some difficult areas to tackle in my figurehead model, I though it was time to do something different. So I chose to model the binnacle of HMS Victory. Plain geometry – something easy and rewarding… 😉 The … Continue reading
Posted in 3D parts, Modeling, Uncategorized
2 Comments